chapter 6000
page 14
1,2 - 2,0 t A.C.
SERVICE MANUAL
Electric
036-0410-07
A
E
C
D
B
C
D
B
HYDRAULIC OIL: AGIP type ARNICA 46
LIFTING EQUIPMENT OIL AND OIL FILTER
The hydraulic oil tank is located under the
platform.
The filter cartridge (A) is beneath the screw
cap (C).
To check and change the oil, place and
stop the truck on a flat surface, with the
mast tilted backwards and the forks
lowered.
After the first 50 hours
- filter change
Every 500 hours
- check the oil level in the tank using
the dip-stick (D);
Every 2000 hours
- replace the oil and the filter.
- check and clean the tank breather valve
filter (B).
To change the filter:
- remove the tank cap (C) and the filter
- fit a new filter after checking the state of
the seals
- after testing, check that there are no oil
leaks
To Next Page
Loading...
