chapter C
page 5
1,2 - 2,0 t A.C.
SERVICE MANUAL
Electric
036-0410-07
Welding
Wear a leather overall, gloves and a welding mask.
It is obligatory to wear gloves and protective goggles during the grinding operations because they could cause
the projection of metallic particles.
Make sure that these two operations are performable inside the working area where you are.
When these operations are carried out on a truck, in order to avoid the danger of explosion, cover and protect
the battery and the parts in contact with fuel carefully.
Make sure that around the working area there are not any inflammable products.
Disconnect the battery and short-circuit the logic units through a resistor (56 Ohm 1W) between the positive
(+) and the negative (-) before carrying out any arc-weldings on the truck.
Truck washing
During this operation be careful when using water on electric components.
To Next Page
Loading...
