© Cesab 5 – 1 T Code(s): 841, 842, 843
Repair manual: Parameters Model(s): S210, S212, S212S, S212L, S214, S214L, S220D
Publication Number: 7588857-040 Date: 2018-05-01 Applies from serial number: 6384351-
5. Parameters
5.1 General
The truck's control system can store a number of different parameters. These
are used to configure the truck according to the task to be performed. The
parameters are divided into groups:
– Operator parameters – The driver parameters (1-100) are used to
adapt the truck’s characteristics to a specific driver or task. Up to 10
operator parameter profiles can be stored.
– Service parameters – The service parameters (range 101–1000) are
used to adapt the truck's performance/response and cover all other
parameters not covered by the operator parameters.
– Factory parameters – (range 1001-1250). Truck-specific parameters.
Operator parameters are displayed and changed only for a selected operator,
but if a CAN service key is connected, the parameters for all operators can
be displayed and changed. Operator parameters can be changed by the
operator if the truck's program is set up for this.
The service parameters can be changed once a suitable CAN service key or
PDA/PC has been connected to the truck.
Factory parameters can only be changed using the TruckCom software
application.
https://www.forkliftpdfmanuals.com/
To Next Page
Loading...
Need help?
General
