Cessna 210B - Servicing and Dealer Information; Lubrication and Servicing

Care of the Airplane
LUBRICATION AND SERVICING
Specific lubrication and servicing information is presented in the Serv-
icing Diagram (figure 6-1). In addition, all pulleys, the trim tab actuator
rod, control surface hinge bearings, bellcrank clevis bolts, brake pedal
pivots, rudder pedal crossbars, shimmy dampener pivot bushings, door
hinges and latches, Bowden controls (with the exception of their friction
locking devices), propeller and cowl flap control ends, throttle and mixture
control linkage, and any other friction points should be lubricated every
lOOO hours, or oftener, with SAE 20 general-purpose oil. Do not lubri-
cate friction locks.
Generally, roller chains (aileron, elevator trim tab wheel and tab
actuator) and control cables collect dust, sand and grit if they are greased
or oiled. Except under seacoast conditions, chains and cables should be
merely wiped clean occasionally with a dry cloth.
DEALER FOLL~W-UP SYSTEM ~
Your Cessna Dealer has an owner fonow-up system
to notify you when he receives information that applies to
your Cessna. In addition, if you wish, you may choose to
receive similar notification directly from the Cessna
Service Department. A subscription card is supplied in
your airplane file for your use, should you choose to re-
quest this service. Your Cessna Dealer will be glad to
supply you with details concerning these follow-up pro-
grams, and stands ready through his Service Department
to supply you with fast, effiCient, low cost service.
1I1 ';COMMENDED FUEL :
AVlATION GRADE
-- 100 /13 0 OCTANE
III-:COMMENDED ENGINE OIL:
AVIATION GRADE - - SAE 30 BELOW 40 ' F
SAE
SO ABOVE 40' F
IIYDRAUUC FLUID:
SPEC. NO. M1L-H-5606
OXYGJ,:N:
SPEC. NO . BB-O-925
Care of the Airplane
SERVICING
DIIAGRAM
SERVICING INTERVALS
o CHECK OR SERVICE DAilY
o SERVICE EVERY 25 HOURS
o SERVICE EVERY SO HOURS
D SERVICE EVERY 100 HOURS
o SERVICE EVERY 500 HOURS
D SERVIC ,E AS REOUIRED
Symbol denotes servi cing interv a l. Number within
symbol refers to item to be serviced as shown in
adj oi nIng specifications.
Figure 6-1 (Sheet 1 of 6). ________ ...1
6-7
6-6