5.2.2 Deactivating office mode
Required:
l
Locking medium that is authorised for the office function
l
Locking device with office function
Procedure:
Steps Signal
1. Hold a locking medium authorised for the office function in the reading field of the
locking device.
The locking medium is read and accepted. 1x long green
2. Continue to hold the locking medium in the reading field of the locking device (for
approx. 2 seconds).
Office mode is deactivated. 1x long green ,
1x short green
Office mode is now deactivated.
Troubleshooting:
Signal Cause Solution
After 2 seconds,
1x long green ,
1x short green
are not displayed.
Office mode cannot be deactivated because
the locking medium is not authorised for the
office function.
Have your locking medium authorised
for the office function by the system
administrator.
Page 16 of 83 Wide shield replacement handle set ILS-I
5.2 Details about the office function
Overview: Use of master media Help & troubleshooting Technical data Maintenance & disposal
Operation
Administration Assembly Basic information
To Next Page
Loading...
