ChargePoint CP6000 - Tools Required; Consumables Required

Tools Required
Electric hammer drill with 12 mm (1/2 in) or larger chuck.
Consumables Required
The following table lists and describes consumable items that you will need. The quantity listed in the table
is based on installation of one charging station.
Note: The consumption rate of these products varies depending on conditions at the installation site.
Quantity Description Purpose
1 Epoxy adhesive for concrete such as Hilti RE-500 Fill drilled holes.
1 Electrical cleaning and maintenance aerosol, any angle
spray duster, 235 ml (8 oz)
Clean drilled holes.
Note: Compressed air
will work.
1 Slow spiral round-shank masonry drill bit
l
19 mm (3/4 in) diameter
l
12.5 mm (1/2 in) shank
l
254 mm (10 in) drill depth
l
305 mm (12 in) length overall
Drill 19 mm (3/4 in)
holes in concrete. Note:
The holes must be at
least 150 mm (6 in)
deep.
1 Drill bit for concrete embedded rebar, round
l
19 mm (3/4 in) bit size
l
12.5 mm (1/2 in) shank diameter
l
305 mm (12 in) length overall
Drill 19 mm (3/4 in) hole
through rebar.
1 Nylon loop handle brush
l
19 mm (3/4 in) brush diameter
l
75 mm (3 in) length brush
l
216 mm (8 1/2 in) length overall
Clean drilled holes.
1 Push-on round cap, fits 16 mm (5/8 in) - 17.5 mm (11/16 in)
OD, 12.7 mm (1/2 in) inside height, pack of 100
Keeps the epoxy inside
the drilled holes in
situations where the
slab is only 150 mm
(6in) deep.
35
Install on Existing Concrete