CHART ULTRADOSER 2K - Installing the Bottle Detect Sensor; Installing the Timing Sensor

Installing the Bottle Detect Sensor
The bottle detect sensor must be a PNP type sensor and is used to detect if containers are present on the
line. Chart provides a PNP 18mm photoelectric sensor with the UltraDoser 2K system. Ideal sensor
placement is about four (4) to six (6) pockets from the dosing head. If the sensor does not detect a
container for the user defined number of seconds, the UltraDoser unit will stop dosing. See
[Inputs/Outputs] [Bottle Sensor] on page 41 for additional information.
See “Appendix A – Sensor Positioning” on page 63 for additional information.
Installing the Timing Sensor
The timing sensor is installed to detect filling line speed and must be installed for the UltraDoser 2K to
operate properly. Chart provides a PNP 12mm inductive proximity sensor with the UltraDoser 2K
system. Ideal sensor placement should provide a one-to-one signal and will vary for each filling line.
See “Appendix A – Sensor Positioning” on page 63 for additional information.