Need help?Do you have a question about the Chatillon DFE I and is the answer not in the manual?
General| Brand | Chatillon |
|---|---|
| Model | DFE I |
| Category | Measuring Instruments |
| Language | English |
Details the instrument's warranty against defects in workmanship, material, and design for one year.
Provides guidance on initial setup, including temperature acclimation for the load cell sensor.
Explains how to turn the DF II Series gauge on and off using the dedicated power key.
Provides instructions on charging the NiMh battery pack and battery life indicators.
Describes the gauge's nine keys and navigation pod for operation and setup.
Explains how to set Pass-Fail limits based on an upper and lower setpoint range.
Explains setting Pass-Fail limits using a nominal value and % bandwidth.
Covers activating Pass-Fail limits and selecting between Range and Nominal Value methods.
Details setting high and low load limits and enabling the load limit buzzer.
Guides on setting the highest compression load value for the high limit setpoint.
Explains setting the lowest tension load limit and viewing load limit results.
Details configuring auto shutdown to preserve battery life and activate the feature.
Covers selecting the correct sensor and understanding full scale capacity and accuracy.
Details powering the gauge, connecting sensors, and issues with improper connections.
Introduces the TCD WEDGE application software for gauge operation and data analysis.
Explains the two types of load averaging tests: Force-Based and Time-Based.
Guides on setting the preload limit and time limit for load averaging tests.
Explains performing a force-based load average test and its associated annunciators.
Introduces break detection and the two test types: Sharp Break and Percentage Drop.
Details the Sharp Break (95% drop) and Percentage Break (% drop) test modes.
Guides on setting up break detection and selecting between Sharp and Percentage break types.
Explains how to select the break point for both Sharp and Percentage Break test methods.
Details how to select the percentage drop value to identify the break load.
Covers performing pull-to-break and compress-to-rupture tests in Sharp Break mode.
Covers performing pull-to-break and compress-to-rupture tests in Percentage Break mode.
Explains how to view and transmit break test results, including detailed information.
Explains how the gauge calculates and displays statistics for saved break test results.
To Next Page
