DF II Series User Manual 49
MOUNTING SLC SENSOR TO TESTER
The SLC Series loadcell sensor may be used with
Chatillon® force testers. A mounting adapter is
required to secure the sensor to the following
testers:
Tester Adapter Part No.
MT150 SPK-MT-0001 & NC000300
MT500 SPK-MT-0004 & NC000300
1
LTCM-100 NC000300
TT Tester NC002582 & NC000300
1
Note: NC000300 CANNOT be used on tests requiring a
capacity greater than 225 lbf (1 kN).
SLC SENSOR CAPACITIES
SLC-250G 8 x 0.002 250 x 0.05 0.5 x 0.0001 0.25 x 0.0001 2.5 x 0.0005
SLC-0002 32 x 0.005 1000 x 0.1 2 x 0.0002 1 x 0.0001 10 x 0.001
SLC-0010 160 x 0.02 5000 x 0.5 10 x 0.001 5 x 0.0005 50 x 0.005
SLC-0025 400 x 0.05 10,000 x 1 25 x 0.002 10 x 0.001 100 x 0.01
SLC-0050 800 x 0.1 25,000 x 2 50 x 0.005 25 x 0.002 250 x 0.02
SLC-0100 1600 x 0.2 50,000 x 5 100 x 0.01 50 x 0.005 500 x 0.05
SLC-0200 - - 200 x 0.02 100 x 0.01 1000 x 0.1
SLC-0500 - - 500 x 0.05 250 x 0.02 2500 x 0.2
SLC-1000 - - 1000 x 0.1 500 x 0.05 5000 x 0.5
SLC Model ozf gf lbf kgf N
SLC Sensors with capacities of 10 lbf (5N) and less, have
a “block-style” design. Higher capacity loadcell sensors
have an “S-type” design.
STS SENSOR CAPACITIES
STS-0003 50 x 0.005 35 x 0.005 3 x 0.0005 3.5 x 0.0005 0.35 x 0.0001
STS-0012 192 x 0.02 125 x 0.02 12 x 0.002 12.5 x 0.002 1.25 x 0.0002
STS-0050 800 x 0.1 500 x 0.05 50 x 0.005 50 x 0.005 5 x 0.0005
STS-0100 - 1000 x 0.1 100 x 0.01 100 x 0.01 10 x 0.001
STS-0200 - 2000 x 0.2 200 x 0.02 200 x 0.02 20 x 0.002
STS Model oz-in N-cm lb-in kg-cm N-m
To Next Page
Loading...
Need help?
General
