DF II Series User Manual 29
SELECTING INCREMENTS
Increments are associated with the numeric values
displayed by the gauge during setup. You select
the increment you want to use to adjust your setup
values. Increments are provided in values
corresponding to the gauge capacity and units of
measure. Increment values available are:
n 0.001
n 0.01
n 0.1
n 1.0
n 10.0
n 100.0
Selecting an increment of 10.0 will adjust the setup
numeric value by “tens”. Selecting the increment
0.1 will adjust the setup numeric value by “tenths”.
You select increments using the RIGHT and LEFT
arrow keys on the navigation pod. Selecting the
RIGHT arrow increases the increment value.
Selecting the LEFT arrow decreases the increment
value.
SELECTING HIGH RANGE LIMIT
Use the F1 key to select the HIGH RANGE Pass-
Fail Limit. The cursor arrow will automatically be
placed next to the HIGH Limit tag indicating that
you are about to adjust this value.
Use the UP and DOWN navigation key to increase
or decrease the High Pass-Fail Limit VALUE. The
value will increase by the increment selected upon
each key press.
Do NOT select ENTER until you have adjusted
both the High and Low Pass-Fail Limits to your
desired setpoints.
To Next Page
Loading...
Need help?
General
