38 DF II Series User Manual
SELECTING LIMITS (RS232, USB AND BLUE-
TOOTH®)
The DF II Series allows you to transmit an ASCII
signal when a Load Limit has been met. This sig-
nal is used to stop crosshead movement on a TCD
Series tester.
A HIGH LIMIT sends the following ASCII string:
$$$$$$$$$$
A LOW LIMIT sends the following ASCII string:
’’’’’’’’’’’’’’’
To enable XMIT LIMITS, position the arrow next
to the XMIT LIMITS tag. Select the RIGHT arrow
on the navigation key to enable this feature (ON).
Select the LEFT arrow on the navigation key to dis-
able this feature (OFF). Select ENTER.
SELECTING BAUD RATE (RS232)
The DF II Series allows you to select the required
baud rate when in RS232 mode.
Position the arrow next to the BAUD tag. Use the
UP and DOWN arrow to specify any of the follow-
ing baud rates:
n 4800
n 9600
n 19200
n 28800
n 38400
n 57600
n 115200
Select ENTER to enable.
To Next Page
Loading...
Need help?
General
