SYSTEM
EN
|
Intelect
®
Mobile 2 ELECTROTHERAPY User Manual
Advice on size and type of electrodes to be used is given in
device GUI treatment guidelines. For additional information
on Waveforms and output energy, refer to APPENDIX on
page .
CC: Constant Current CV: Constant Voltage
WAVEFORMS
TENS- Asymmetrical Biphasic
Advice on size and type of electrodes to be used is given in device GUI "treatment guidelines" feature
The Asymmetrical Biphasic waveform has a short pulse duration. It is capable of
strong stimulation of the nerve fibers in the skin as well as of muscle tissue. This
waveform is often used in TENS devices.Because of its short pulse, the patient
typically tolerates the current well, even at relatively high intensities.
Output Mode Electrodes
Output Intensity - mA (CC) - V (CV)
Available on Channel ,
Treatment Time (Stim) - minutes
Mode Selection (Stim) CC or CV
Amplitude Modulation % (o) to % on % steps
Burst Frequency - bps
Cycle Time Continuous or User Defined
Frequency - pps
FrequencySweep On/O
Phase Duration - µsec
Sweep time sec
Sweep Low Frequency - pps
Sweep High Frequency - pps
IRMS -mA
DC component No
IFC (Interferential) Traditional ( Pole)
Advice on size and type of electrodes to be used is given in device GUI "treatment guidelines" feature
Interferential Current is a medium frequency waveform. Current is distributed
through two channels (four electrodes). The currents cross each other in the body
at the area requiring treatment. The two currents interfere with each other at
this crossing point, resulting in a modulation of the intensity (the current intensity
increases and decreases at a regular frequency).
Output Mode Electrodes
Available on Channel &,
Treatment Time - Minutes
Mode Selection CC
Output intensity - mA (CC)
Beat Frequency - Hz
Carrier Frequency -, Hz
Cycle Time Continuous or User Defined
Sweep Time sec
Sweep Low Beat Frequency - Hz
Sweep High Beat Frequency - Hz
Scan Percentage Static, %, %, Manual
IRMS -mA
DC component No
To Next Page
Loading...
Need help?
General
