Configuring Through a Web Browser
CHCNAV iBase GNSS USER GUIDE | 2023-2 P a g e | 34
Steps:
(1) Insert the batteries into the receiver.
If work as a cellular rover station, the SIM card need to be inserted before the batteries.
(2) Screw the receiver onto the pole.
If work as a UHF rover station, the UHF whip antenna need to be connected to the receiver.
(3) Turn on the receiver by pressing the power button for 3 s.
(4) Switch on the data controller and connect it to the receiver.
(5) Use software to configure the receiver as cellular rover or UHF rover mode.
(6) Center and level the receiver more precisely.
(7) Use software to start survey.
5 Configuring Through a Web Browser
Supported browsers:
• Google Chrome
• Microsoft Internet Explorer
○
R
version 10, or higher
To connect to the receiver through a web browser:
1. Turn on the Wi-Fi of the receiver.
2. Search the wireless network named as GNSS-XXXXXXX (the SN of your receiver) on your
computer, and then establish the connection.
3. After the successful connection between your computer and the receiver, enter the IP
address (192.168.1.1) of the receiver into the address bar of the web browser on your
computer:
To Next Page
Loading...
