Check Point 5000 Appliances Getting Started Guide | 29
CHAPTER 3
Configuring 5000 Appliances
In This Section:
Starting the Appliance ......................................................................................... 29
Initial Configuration ............................................................................................. 30
Creating the Network Object .............................................................................. 31
Advanced Configuration ...................................................................................... 31
Starting the Appliance
Connect the appliance to a power source and turn on the appliance. When the
appliance is ready, you can do the First Time Configuration Wizard to configure it.
To start the appliance:
1. For 5200 and 5400 - Connect the power cable to the power supply unit in the rear
panel.
For 5600 and 5800 - Connect the power cable(s) to the power supply unit(s) in the
rear panel. You will have two power cables only if you purchased an optional dual
redundant hot-swappable power supply .
2. From the rear of the appliance, turn on the Power button.
The appliance turns on.
I
n 5600 and 5800 appliances with two power supply units installed:
Note - When a power supply unit is not connected to the outlet or is taken
out of the appliance, an alarm sounds continuously. It will continue to
beep until power is restored (cord or power supply unit is replaced) or
the alarm is turned off.
To turn off the alarm, press the red Alarm off button on the rear panel of
the appliance.
To Next Page
Loading...
