Electrical Safety Analyzer 19032-P Quick Start Guide
19
S1: T test setting in
S2: ited with COM, recall/read test setting in
S3: d with COM, recall/read test setting in
(10) 9Pin -Sub connector functions are the same
r socket and fuse holder.
AC power, which the
his
(12) GND Term ety GND terminal, please use adaptable implement
wer cable, please confirm power that use firstly
urning on power, please peruse “Chapter 3 – Precaution before
e analyzer will self-test. If there is abnormal
specification 125V AC current is lower than 1A.
he terminal is short-circuited with COM, recall/read
the first group memory.
The terminal is short-circu
the second group memory.
The terminal is short-circuite
the third group memory.
Connector: All of 9 pin D
as (9) Remote I/O.
(11) AC LINE: AC powe
A tri-cord power and fuse holder. Input
analyzer is needed from AC power socket. The detailed
specification of using fuse please refers “Chapter 3 –
Precaution before Use” or descriptions of rear panel in t
manual.
inal: Saf
to connect this grounding terminal actually. If there is
no grounding actually, the circuit with GND terminal or
other instruments connecting cable with GND terminal
is short circuit. The cover of analyzer may exist high
voltage. This is very dangerous, anyone touch the
analyzer under the above status may cause damage.
Therefore, it is necessary to connect safety GND
terminal to ground.
4.3 Notice Items and Procedures before
Operating
1. Before plugging AC po
and description of rear panel is match or not and power switch is OFF
status.
2. Before t
Use” and remember it.
3. When turns on power, th
condition, please turns off switch and pulls off power cord immediately.
To Next Page
Loading...
Need help?
General
