Electrical Safety Analyzer 19032-P Quick Start Guide
24
4.5 Memory Management of Test Parameter
and Test Preset Parameter
When title display “MAIN MENU”, press Function Key [MEMORY] and then
title will display “MEMORY SETUP”. At the same time, the memory can
be read, stored or deleted. Each memory includes test parameter, test
preset parameter and memory name.
4.5.1 Read Memory
1. If there are many sets of test parameter value, which be saved in main
memory. Follow the below procedures to recall test parameter.
2. When title display “MEMORY SETUP”, press [U], [V] keys or Function
Key [NEXT PAGE] to move the highlighted cursor to the memory name
which want to recall.
3. Press Function Key [RECALL] and then show confirm window.
4. Press [ENTER] to confirm or press Function Key [EXIT] to cancel.
4.5.2 Store Memory
1. If you want to save testing parameter data which be set in memory.
Please follows the below procedures to process. When title display
“MEMORY SETUP”, press [U], [V] keys or Function Key “NEXT
PAGE” to move the cursor highlight to the memory number position
which want to store.
2. Press Function Key [STORE], the highlighted cursor become
underscore blinking cursor. At the same time, input the memory
name by using numeral/character keys. Press the same
numeral/character keys repeatedly can circle switch display between
numeral and alphabet. If you want to input name, can use Function
Key [NEXT CHAR.] to move the underscore blinking cursor to next
character.
3. Press [ENTER] to confirm or press Function Key [EXIT] to cancel.
4.5.3 Delete Memory
1. If you want to delete test parameter data which be stored in memory.
To Next Page
Loading...
Need help?
General
