High Power DC Electronic Load 63200 Series Operation & Programming Manual
Select data entry mode by ENTER. If YES is selected for data entry, the setting will go to
the next one after pressing ENTER. If NO is selected for data entry, the setting will remain
at the same line for you to change it again and again. The default setting is NO.
Select SOUND ENABLE. When you press the key on the module, it will produce a sound if
sound = YES. The default setting for sound is YES.
Select Load input status when it is powered ON. If YES is selected, the module will be
active according to AUTO LOAD ON mode setting. The default setting of AUTO LOAD
ON is NO.
Select the load on mode if AUTO LOAD ON is ON. If LOAD is selected, the Load will be
active as DEFAULT setting. If PROG is selected, the Load will be active as the program
saved last time. The default setting of AUTO LOAD ON MODE is LOAD.
Select short key mode. Set SHORT key mode for the Load. The default setting of SHORT
mode is TOGGLE.
Display the versions of host, load, and Panel.
Press ▼ key and the display will show:
<HOST FW> WRTR: 00.85
BOOT: 00.85 MAIN: 00.85
SHORT KEY MODE
1: TOGGLE 2: HOLD
AUTO LOAD ON MODE
1: PROG 2: LOAD
AUTO LOAD ON
1: YES 2: NO
SOUND ENABLE
1: YES 2: NO
ENTER DATA NEXT
1: YES 2: NO
SPEC. ENTRY MODE
1: VALUE 2: PCet
4-16
To Next Page
Loading...
