Language Dictionary
Return Example Chroma,63203,12345678,01.00
*OPC Operation Complete Command
Description This command causes the interface to set the OPC bit (bit 0) of the
Standard Event Status register when the Electronic Frame (6320) has
completed all pending operations.
Syntax *OPC
Parameters None
*OPC? Operation Complete Query
Description This query returns an ASCII “1” when all pending operations are
completed.
Query Syntax *OPC?
Return Parameters <NR1>
Query Example 1
*RCL Recall Instrument State Command
Description This command restores the electronic load to a state that was
previously stored in memory with *SAV command to the
specified location (see *SAV).
Syntax *RCL <NRf>
Parameters 1 to 100
Example *RCL 50
*RST Reset Command
Description This command forces an ABORt, *CLS, LOAD:PROT:CLE
command.
Syntax *RST
Parameters None
*SAV Save Command
Description This command stores the present state of electronic load in a
specified location in memory.
Syntax *SAV <NRf>
Parameters 1 to 100
Example *SAV 50
*SRE Service Request Enable Command/Query
Description This command sets the condition of the Service Request Enable
register to determine which event of the Status Byte register (see
*STB) is allowed to set the MSS (Master Status Summary) bit. A
"1" in the bit position enabled by bits is
logically ORed to cause Bit
6 (the Master Summary Status Bit)
of the Status Byte register to be
set. See details regarding the
Status Byte register in Chapter 8
Status Reporting.
Syntax *SRE <NRf>
7-3
To Next Page
Loading...
