Chroma 63205 - Page 88

High Power DC Electronic Load 63200 Series Operation & Programming Manual
Parameters 0 | RESISTANCE, 1 | POWER
Example CONF:DISP POWER Set the power display mode.
CONF:DISP 0 Set resistance display mode.
Query Syntax CONFigure:DISPlay?
Return Parameters 0 | 1
Query Example CONF:DISP? Return the execution type of display mode.
Return Example 1 (POWER)
CONFigure:KEY
Description Set enter data key mode
Command Syntax CONFigure:KEY <NR1 | CHAR>
Parameters 0 | NEXT, 1 | HOLD
Example CONF:KEY 0 Set enter data next mode.
CONF:KEY HOLD Set enter data hold mode.
Query Syntax CONFigure:KEY?
Return Parameters 0 | 1
Query Example CONF:KEY? Return the execution type to enter data mode.
Return Example 0 ( NEXT )
CONFigure:REMote
Description Set the status of remote control (only effective in RS232C).
Syntax CONFigure:REMote <NR1 | CHAR>
Parameters 0 | OFF, 1 | ON
Example CONF:REM ON Set to remote control.
CONFigure:SAVE
Description Store CONFigure data into EEPROM.
Syntax CONFigure:SAVE
Parameters None
Example CONF:SAVE
CONFigure:SOUNd
Description Set the buzzer sound ON/OFF.
Syntax CONFigure:SOUNd <NR1 | CHAR>
Parameters 0 | OFF, 1 | ON
Example CONF:SOUN 0
CONF:SOUN OFF
Query Syntax CONFigure:SOUNd?
Return Parameters 0 | 1
Query Example CONF:SOUN? Return the control status of the buzzer sound.
Return Example : 0 (OFF )
CONFigure:VOLTage:LATCh
Description Set the action type to Von.
Syntax CONFigure:VOLTage:LATch <NR1 | CHAR>
Parameters 0 | OFF, 1 | ON
Example CONF:VOLT:LAT 1 Set the action type to Von as Latch.
7-6