WARNING!
Always make sure the head restraint is in its upright position when the seat is to be used by an
occupant who is not in a child restraint. Sitting in a seat with the head restraint in its lowered
position could result in serious injury or death in a collision.
Installing A Child Restraint With A Swit-
chable Automatic Locking Retractor
(ALR):
Child restraint systems are designed to be se-
cured in vehicle seats by lap belts or the lap belt
portion of a lap/shoulder belt.
WARNING!
• Improper installation or failure to properly secure a child restraint can lead to failure of the
restraint. The child could be badly injured or killed.
• Follow the child restraint manufacturer’s directions exactly when installing an infant or child
restraint.
1. Place the child seat in the center of the seating position. For some second row seats, you may
need to recline the seat and/or raise the head restraint to get a better fit. If the rear seat can be
moved forward and rearward in the vehicle, you may wish to move it to its rear-most position
to make room for the child seat. You may also move the front seat for ward to allow more room
for the child seat.
2. Pull enough of the seat belt webbing from the retractor to pass it through the belt path of the
child restraint. Do not twist the belt webbing in the belt path.
3. Slide the latch plate into the buckle until you hear a “click.”
4. Pull on the webbing to make the lap portion tight against the child seat.
Car Seat With Head Restraint Folded
1 – Folded Headrest
2 – Child Restraint
GETTING STARTED
61
To Next Page
Loading...
