Driver Memor y Seat — If Equipped
The Memory Buttons (1) and (2) on the driver's door panel can be programmed to recall the
driver's seat, outside mirrors, and radio station preset settings. Your key fobs can also be
programmed to recall the same positions when the unlock button is pushed.
Your vehicle may have been delivered with two
key fobs, one key fob can be linked to each of
the memory positions.
Programming The Memory Feature
To create a new memory profile, perform the
following:
1. Cycle the vehicle’s ignition to the ON/RUN
position (do not start the engine).
2. Adjust all memory profile settings to desired
preferences (i.e., driver’s seat, outside mir-
rors and radio station presets).
3. Push and release the set (S) button on the memory switch.
4. Within five seconds, push and release either of the memory buttons (1) or (2). The instrument
cluster display will show which memory position has been set.
NOTE:
• Memory profiles can be set without the vehicle in PARK, but the vehicle must be in PARK to
recall a memory profile.
• To set a memory profile to your key fob, refer to “Linking And Unlinking The Remote Keyless
Entry Key Fob To Memory” in this section.
Linking And Unlinking The Remote Keyless Entry Key Fob To Memory
Your key fob can be programmed to recall one of two pre-programmed memory profiles by
pushing the unlock button on the key fob.
NOTE:
Before programming your key fob you must select the “Personal Settings Linked to Key Fob”
feature through the Uconnect Settings. Refer to “Uconnect Settings” in “Multimedia” in your
Owner’s Manual on www.chrysler.com/en/owners/manuals for further information.
To program your key fob, perform the following:
1. Cycle the vehicle’s ignition to the OFF position.
2. Select a desired memory profile 1 or 2.
NOTE:
If a memor y profile has not already been set, refer to "Programming The Memory Feature" in this
section for instructions on how to set a memory profile.
Driver Memory Switch
GETTING STARTED
74
To Next Page
Loading...
