3. Once the profile has been recalled, push and release the set (S) button on the memory switch.
4. Push and release button (1) or (2) accordingly. “Memory Profile Set” (1 or 2) will display in the
instrument cluster.
5. Push and release the lock button on the key fob within 10 seconds.
NOTE:
Your key fob can be unlinked to your memory settings by pushing the set (S) button, and within
10 seconds, followed by pushing the unlock button on the key fob.
Memory Position Recall
NOTE:
The vehicle must be in PARK to recall memory positions. If a recall is attempted when the vehicle
is not in PARK, a message will be displayed in the instrument cluster display.
To recall the memory settings for driver one, push memory button (1) on the driver's door or the
unlock button on the key fob linked to memory position 1.
To recall the memory setting for driver two, push memory button (2) on the driver's door or the
unlock button on the key fob linked to memory position 2.
A recall can be cancelled by pushing any of the memory buttons on the driver's door during a
recall (S, 1, or 2). When a recall is cancelled, the driver's seat stops moving. A delay of one second
will occur before another recall can be selected.
NOTE:
Pushing the mirror adjust switch will cancel the memory mirror recall.
Easy Entry/Exit Seat (Available With Memory Seat Only)
This feature provides automatic driver seat positioning to enhance driver mobility when entering
and exiting the vehicle.
The distance the driver seat moves depends on where you have the driver seat positioned when
you cycle the vehicle’s ignition to the OFF position.
• When the ignition switch transitions to the LOCK position, the driver seat will move about
2.4 inches (60 mm) rearward if the driver seat position is greater than or equal to 2.7 inches
(67.7 mm) forward of the rear stop. The seat will return to its previously set position when the
ignition switch transitions out of the LOCK position.
• When the ignition switch transitions out of the LOCK position, the driver seat will move to a
position 0.3 inches (7.7 mm) forward of the rear stop if the driver seat position is between 0.9
– 2.7 inches (22.7 – 67.7 mm) forward of the rear stop. The seat will return to its previously set
position when the ignition switch transitions out of the LOCK position.
• The Easy Entry/Easy Exit feature is disabled when the driver seat position is less than 0.9
inches (22.7 mm) forward of the rear stop. At this position, there is no benefit to the driver by
moving the seat for Easy Exit or Easy Entry.
Each stored memory setting will have an associated Easy Entry and Easy Exit Position.
GETTING STARTED
75
To Next Page
Loading...
