System
Settings
Ringing Times
Alarm Message
Record
Input 4 Digits
User ID<1234>
Arm Upload
Disarm Upload
Reset
On
Off
On
Off
Wired Siren
Wireless Siren
Built-in Siren
Siren Setup
Siren Alert Time
<300S>
Siren On/Off <On/Off>
Arm/Disarm Tone <On/Off>
Siren On/Off <Off/Low/High>
Arm/Disarm Tone <On/Off>
Siren On/Off <On/Off>
Arm/Disarm Tone <On/Off>
History
1
2
3
4
1
2
3
4
Settings
When LCD is activated, input the admin code (Default: 123456), and then press [Enter]
to enter setting menu.
1. Alarm Phone Number Setup
User can set 6 user phone numbers and 2 CMS phone numbers. When connecting to
CMS, system will dial CMS phone number to upload Contact ID reports while alarming
and then dial 6 user phone numbers in sequence one by one. System will dial all the
user phone numbers in 3 cycles until the phone is answered together with any
operation on phone buttons.
Add Alarm Phone Number
Log on the menu, choose “Phone Numbers”, press .[Enter]
Press or , choose “Add Phone Number”, press .[ ] [ ] [Enter]
Press or , choose “Alarm Number1~6”, press .[ ] [ ] [Enter]
Input alarm phone numbers in order, press . If group extended telephone [Enter]
number is used, 0# or 9# need to be added in front of the phone number.
Note: If user wants to check or edit the stored phone number, enter “Alarm Number1~6” to
check and edit.
Delete Alarm Phone Number
Log on the menu, choose “Phone Numbers”, press .[Enter]
Press or , choose “Delete Phone Number”, press . [ ] [ ] [Enter]
Press or , choose “Alarm Number1~6”, press .[ ] [ ] [Enter]
Delete the alarm phone numbers in order, press again.[Enter]
Note: If user wants to set CMS center phone number, please refer to “Connect to CMS Center”.
27
28
Language
Important: The default language of this alarm system is English, you can change in the
[Language] [System Setting] menu of .
To Next Page
Loading...
