You can control the system by sending SMS commands to the SIM card No. SMS is
charged according to telecom operator.
Any phone number can send SMS to control the system by default, after you store
alarm phone numbers to the control panel, system accepts only the commands from
these numbers.
This is to disarm the system. In disarmed status, the detectors (except those accessories
in the 24-hour zone) will not trigger an alarm when detecting intrusion.
This is to arm the system. In armed status, the system will trigger an alarm when
detecting intrusion.
SMS Operation
Disarm
Arm (Away Arm)
0
System disarmed.
1
System armed.
Home Mode (Part Arm)
Monitor
In home mode, detectors setting to home mode zone are in disarmed status; the other
detectors are still in armed status. That is, you can move freely in the home mode zone;
however, the rest areas are still being protected.
This is to monitor the site remotely by call-back from the control panel.
After the control panel receives the SMS, it calls your phone number. Then, you can
answer the call and monitor (listen in) the site.
2
System in home mode.
3
Recording Voice Memo
This is to record a 10-second voice memo by call-back from the control panel.
After the control panel receives the SMS, it calls your phone number. Answer the phone
and then you can start to record a 10-second voice memo. The control panel will hang
up phone after 10 seconds.
4
43
44
To Next Page
Loading...
