13
2.5 GAS INSTALLATION
This Appliance must be installed by a qualied plumber /gas tter who can provide a certicate of compliance in
accordance with AS/NZS 5601.1. This appliance is designed to be used with ULPG gas and is to be installed with
rigid piping only.
CAUTION!
• This toilet must only be connected to the gas supply by an authorised person in
accordance with the technical and administrative regulations of the country in which
the toilet is installed, i:.e. AS/NZS 5601.1.
• Only operate the toilet at the pressure shown on the type plate on the back of the
toilet.
• Only operate the toilet with the type of gas shown on the type plate on the back of
the toilet.
• The toilet is suitable only for indoor installation
SPECIFICATIONS VALUE NOTES
Fuel consumption 9.8 MJ/h
Inlet gas pressure 2.75 kPa
Gas type ULPG
Gas connection appliance ¼’’ NTP female
Male straight increaser threaded tting ¼’’ NTP to ¼’’ BSP Delivered with appliance
Elbow 90 degree angled threaded tting ¼’’ BSP to ½” BSP Delivered with appliance
Gas installation Rigid pipes only In accordance with AS/NZS 5601.1.
Orice size 1 mm
To Next Page
Loading...
