24
NOTE!
Make sure to dry the external
part of the insert before
reinserting it into the ash
container
7 8
NB!
• Do not use any sharp tools or objects when cleaning the ash container insert, as this will
damage the insert and reduce its service life.
• Make sure to dry the external part of the insert before reinserting it into the ash
container
NOTE!
In order to preserve the functionality of the toilet in the best possible way, we recommend
that you carry out the “steam cleaning” procedure in accordance with section 4.2.2 every
time you empty and wash the insert. This will prevent the possible accumulation of tar and
unwanted deposits in the catalytic converter and toilet exhaust system.
4.2.2 STEAM-CLEANING THE CATALYTIC CONVERTER
Recommended frequency: weekly or when emptying the ash container. To perform steam cleaning:
1. Ensure that the toilet is cold and the ash container has been emptied and cleaned (see section 4.2.1).
2. Remove the front cover and release the ash container .
3. Pour approximately 1 L of clean water into the toilet insert.
4. Insert the ash container carefully without spilling any water, and attach the front cover.
5. Lift the lid and verify that the fan starts spinning.
6. Press “Start” to begin an incineration cycle.
7. The water will start to boil and the steam will clean the exhaust system. This system cleaning will normally
take 60–70 minutes.
4 6 7
60-80 minutes
5
1
2 3
To Next Page
Loading...
