09.01.l. clock
09.01.m. out of service
09.01.n. product qty
09.01.o. maintenance
09.01.p. RFID CARD
09.01.q. tuning motors
09.01.r. flux product
09.01.s. product audit
09.01.t. id. machine
09.01.a. button from 1
to 8 / 10
“functioning”
to set up the machine clock;
to record any failure that may have occurred;
to check and enable product dispensing cycles;
it contains the maintenance control parameters of the machine;
to determine the RFID card parameters;
to regulate the speed of the boiler pumps, in I machines, and of
the product motors;
to programme the product quantities dispensed within the time
unit;
to audit the product quantities dispensed;
it contains the machine identification parameters;
press key “2” when the display shows “button n” to scroll the
variables composing the function of that key;
the display shows:
and pressing “4” and “5”, the display shows:
- if you press “2” when “FUNCTIONING”, the key will perform the
function you have programmed (dispensing cycle of a drink);
see paragraph “functioning”;
- if you press “2” when “INHIBITED”, the key will be inhibited and
it will perform no function;
- if you press “2” when “PRESELECTION”, the key you have pressed
before the real selection will fulfil the function of the items listed
in the “pre-selection” paragraph;
use key “2” to scroll the following items:
choose the “extended” option to display all variables and the
“reduced” option to display only the parameters, the values of
which are other than zero (use keys “4” and “5” to change the
option);
in E machines, espresso coffee is the first product you can
programme for each selection key; there are three variables:
- the water quantity in the cup; change it by means of “4” and
“5”; if the variable is zero, no espresso will be dispensed (drink
composed by instant products only);
- coffee will be dispensed before (value 1) or after (value 0) instant
products;
- if set to 1, espresso will be dispensed twice during the same
selection;
press “2” to display:
press keys “4” and “5” to change the rotation time of the N product
motor, thus changing the product quantity you have dispensed; if
time is zero, no product N will be dispensed; you can carry out a
“time test” on the set-point; (see 13.18.);
Double coffee
0=no 1=yes N
PROGRAMMING
FLUX PRODUCT
PRODUCT AUDIT
PROGRAMMING
CLOCK
REGISTRATION
OUT OF SERVICE
PROGRAMMING
PRODUCT QTY
PROGRAMMING
MAINTENANCE
PROGRAMMING
RFID CARD
PROGRAMMING
PRODUCT MOTORS
PROGRAMMING
ID MACHINE
COFFEE WATER
0= inhib. cc: 00
coffee sequence
1=coffee before 0.0
FUNCTIONING
INHIBITED
PRESELECTION
programming:
TOTAL
programming:
PARTIAL
PRODUCT N
0= inhib. 0.0
cino eC by
MAN1010105 rel. 03 dated 12.02.2014 page no. 28 of 50 page
www.rheavendors.com tel: 0039 02 966 551 fax: 0039 02 96 55 086 e mail: rheavendors@rheavendors.com
rheavendors group's sole property
To Next Page
Loading...
