Contents
xx
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
MLP Bundles 22-3
Restrictions for MLP Bundles 22-3
MLP Bundles and PPP Links 22-3
System Limits for MLP Bundles 22-4
Types of MLP Bundle Interfaces 22-4
MLP Groups 22-5
MLP Group Interfaces and Virtual Template Interfaces 22-6
How MLP Determines the Link a Bundle Joins 22-6
IP Addresses on MLP-Enabled Links 22-7
Valid Ranges for MLP Interfaces 22-8
MLP Overhead 22-9
Configuration Commands for MLP 22-9
interface multilink Command 22-9
ppp multilink Command 22-10
ppp multilink fragment-delay Command 22-10
ppp multilink interleave Command 22-11
ppp multilink fragment disable Command 22-12
ppp multilink group Command 22-12
MLP over Serial Interfaces 22-13
Performance and Scalability for MLP over Serial Interfaces 22-14
Restrictions and Limitations for MLP over Serial Interfaces 22-14
Single-VC MLP over ATM Virtual Circuits 22-15
Performance and Scalability for Single-VC MLP over ATM 22-15
Restrictions and Limitations for Single-VC MLP over ATM 22-15
Multi-VC MLP over ATM Virtual Circuits 22-16
Performance and Scalability for Multi-VC MLP over ATM VCs 22-17
Restrictions and Limitations for Multi-VC MLP over ATM VCs 22-17
MLP on LNS 22-18
About MLP on LNS 22-19
PPP multilink links max Command 22-21
Performance and Scalability of MLP on LNS 22-21
PXF Memory and Performance Impact for MLP on LNS 22-21
Scenario 1 22-22
Scenario 2 22-22
Restrictions and Limitations for MLP on LNS 22-23
Configuring MLP on LNS 22-24
MLPoE LAC Switching 22-24
Restrictions for MLPoE LAC Switching 22-24
To Next Page
Loading...
