Cisco 10000-2P2-2DC

To Next Page

To Previous Page

Contents

xxi

Cisco 10000 Series Router Software Configuration Guide

OL-2226-23

MLPoE at PTA 22-25

ATM Overhead Accounting 22-26

Prerequisites of MLPoE at PTA 22-26

Restrictions of MLPoE at PTA 22-26

Memory and Performance Impact of MLPoE at PTA 22-27

MLP-Based Link Fragmentation and Interleaving 22-27

Configuring MLP Bundles and Member Links 22-27

Creating an MLP Bundle Interface 22-28

Configuration Example for Creating an MLP Bundle Interface 22-29

Enabling MLP on a Virtual Template 22-30

Configuration Example for Enabling MLP on a Virtual Template 22-31

Adding a Serial Member Link to an MLP Bundle 22-31

Adding an ATM Member Link to an MLP Bundle 22-32

Configuration Example for Adding ATM Links to an MLP Bundle 22-34

Moving a Member Link to a Different MLP Bundle 22-35

Removing a Member Link from an MLP Bundle 22-36

Changing the Default Endpoint Discriminator 22-37

Configuration Example for Changing the Endpoint Discriminator 22-37

Configuration Examples for Configuring MLP 22-38

Configuration Example for Configuring MLP over Serial Interfaces 22-38

Configuration Example for Configuring Single-VC MLP over ATM 22-38

Configuration Example for Configuring Multi-VC MLP over ATM 22-39

Configuration Example for MLP on LNS 22-39

Configuration Example for MLPoE LAC Switching 22-41

Configuration Examples of MLPoE at PTA 22-41

Configuring MLPoE over IEEE 802.1Q VLANs 22-42

Configuring MLPoE through RADIUS 22-42

Verifying and Monitoring MLP Connections 22-43

Bundle Counters and Link Counters 22-44

Verification Examples for MLP Connections 22-44

Verification Example for the show interfaces multilink Command 22-44

Verification Example for the show ppp multilink Command 22-45

Verification Example for the show interfaces multilink stat Command 22-46

Cisco 10000-2P2-2DC - Page 21