Cisco 10000-2P2-2DC - Page 22

Contents
xxii
Cisco 10000 Series Router Software Configuration Guide
OL-2226-23
Configuring QoS Service Policies on GEC Interfaces 23-3
Restrictions for QoS Service Policies on GEC Bundles 23-5
Configuration Examples 23-5
Configuration Example for Using the VLAN Group Feature to Apply QoS on Member Links 23-5
Configuration Example for Applying QoS on GEC Bundle Subinterfaces 23-6
Configuring Policy Based Routing Support on a GEC Bundle 23-7
Restriction for Configuring PBR Support on a GEC Bundle 23-7
Configuring IEEE 802.1Q and QinQ Support on GEC Bundle 23-7
Prerequisites for Configuring IEEE 802.1Q and QinQ Support 23-7
Restrictions for Configuring IEEE 802.1Q and QinQ Support on GEC Bundle 23-7
Configuration Tasks for IEEE 802.1Q and QinQ on Subinterfaces 23-8
Configuration Examples 23-8
Configuring MVPN Support on GEC Bundle 23-9
Configuration Tasks and Examples 23-9
Configuring PPPoX Support on a GEC Bundle 23-9
Restrictions for Configuring PPPoX Support for GEC Bundle 23-9
Configuration Tasks 23-10
Configuration Examples 23-10
Configuring High Availability Support on GEC Bundle 23-11
Configuring 8 Member Links per GEC Bundle 23-11
Configuration Tasks 23-11
Configuring VLAN-Based Load Balancing 23-12
Restrictions for VLAN-Based Load Balancing 23-12
Configuration Tasks 23-13
Configuration Example 23-14
Configuration Example of VLAN-Based Load Balancing 23-14
Configuration Example for Applying VLAN QoS on GEC Bundle Subinterfaces 23-15
Configuration Example for Using the VLAN Group Feature to Apply QoS 23-16
CHAPTER 24 Configuring IP Version 6 24-1
Feature History for IPv6 24-1
Supported Features 24-1
Limitations for IPv6 24-3
IPv6 Extended ACLs 24-4
Prerequisites 24-4
Restrictions 24-4
Configuring IPv6 Traffic Filtering 24-5
Creating and Configuring the IPv6 ACL 24-5