Cisco 350 Series Administration Guide

Administration: File Management
DHCP Auto Configuration/Image Update
112 Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4
7
DHCP Auto Configuration/Image Update
The DHCP Auto Configuration/Image Update page is used to configure the device as a DHCP
client.
The following defaults exist on the system:
• Auto Configuration is disabled.
• Auto Image Update is disabled.
• The device is enabled as a DHCP client.
• Remote SSH server authentication is disabled.
Before You Start
To use this feature, the device must either be configured as a DHCPv4 or DHCPv6 client. The
type of DHCP client defined on the device is in correlation with the type of interfaces defined
on the device.
Auto Configuration Preparations
To prepare the DHCP and TFTP/SCP servers, do the following:
TFTP/SCP Server
• Place a configuration file in the working directory. This file can be created by copying
a configuration file from a device. When the device is booted, this becomes the
Running Configuration file.
DHCP Server
Configure the DHCP server with the following options:
• DHCPv4:
- 66 (single server address) or 150 (list of server addresses)
- 67 (name of configuration file)
• DHCPv6
- Option 59 (server address)
- Options 60 (name of configuration file plus indirect image file name, separated by
a comma)

Cisco 350 Series Specifications

General

Model	Cisco 350 Series
Category	Switch
Ports	8, 24, 48
PoE	Available on some models
Layer	Layer 2
Switching Capacity	Up to 104 Gbps
VLAN Support	Yes (up to 256 VLANs)
QoS	Yes
Management	Web, CLI, SNMP
Security Features	ACLs, 802.1X, Port Security
Jumbo Frame Support	Yes
Power Supply	Internal
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	10% to 90% non-condensing
Port Type	Gigabit Ethernet, Fast Ethernet (depending on model)