Cisco 350 Series Administration Guide

IP Configuration
IPv4 Management and Interfaces
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 303
16
• Reason—
- No Problem
- No Resource
- No Snoop VLAN
- Trust Port
STEP 2 To add an entry, click Add.
STEP 3 Enter the fields:
• VLAN ID—VLAN on which packet is expected.
• MAC Address—MAC address of packet.
• IP Address—IP address of packet.
• Interface—Unit/Slot/Interface on which packet is expected.
• Type—The possible field values are:
- Dynamic—Entry has limited lease time.
- Static—Entry was statically configured.
• Lease Time—If the entry is dynamic, enter the amount of time that the entry is to be
active in the DHCP Database. If there is no Lease Time, check Infinite.)
STEP 4 Click Apply. The settings are defined, and the device is updated.
DHCP Server
This section covers the following topics:
•Overview
• Properties
•Network Pool
• Excluded Addresses
• Static Hosts
• DHCP Options

Cisco 350 Series Specifications

General

Model	Cisco 350 Series
Category	Switch
Ports	8, 24, 48
PoE	Available on some models
Layer	Layer 2
Switching Capacity	Up to 104 Gbps
VLAN Support	Yes (up to 256 VLANs)
QoS	Yes
Management	Web, CLI, SNMP
Security Features	ACLs, 802.1X, Port Security
Jumbo Frame Support	Yes
Power Supply	Internal
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	10% to 90% non-condensing
Port Type	Gigabit Ethernet, Fast Ethernet (depending on model)