Cisco 350 Series Administration Guide

Smart Network Application (SNA)
DAC Workflow
Cisco 350, 350X and 550X Series Managed Switches, Firmware Release 2.4, ver 0.4 513
25
If a rejection event is received from a device that is not a DAC RADIUS server, the message is
ignored, and all further messages from this device for the next 20 minutes are ignored. After
20 minutes, SNA checks again if the device is a DAC RADIUS server. If a user is added to the
whitelist, the device is added to the DAC group of all DAC servers. When this configuration is
saved, you can decide whether to save this setting immediately to the server's startup-
configuration (this option is selected by default).
Until a device is added to the white-list, it is not allowed access to the network.
You can view and change the white and black lists at any time, as long as a DAC RADIUS
server is defined and reachable.
When applying the DAC settings, you are presented with a report listing actions that will be
applied to the participating devices. After you approve the changes, you can decide if the
settings should additionally be copied to the startup configuration file of the configured
devices (this option is selected by default). Finally, apply the configurations.
The report displays warnings if some steps of the DAC configuration process are missed,
along with the status of the actions as handled by the devices.

Cisco 350 Series Specifications

General

Model	Cisco 350 Series
Category	Switch
Ports	8, 24, 48
PoE	Available on some models
Layer	Layer 2
Switching Capacity	Up to 104 Gbps
VLAN Support	Yes (up to 256 VLANs)
QoS	Yes
Management	Web, CLI, SNMP
Security Features	ACLs, 802.1X, Port Security
Jumbo Frame Support	Yes
Power Supply	Internal
Dimensions	Varies by model
Weight	Varies by model
Operating Temperature	0°C to 45°C (32°F to 113°F)
Storage Temperature	-20°C to 70°C (-4°F to 158°F)
Humidity	10% to 90% non-condensing
Port Type	Gigabit Ethernet, Fast Ethernet (depending on model)