Cisco 5010 - Creating a System Event Source; Creating a Timer Event Source; Editing an Event Source; Deleting an Event Source

3-37
Cisco Video Surveillance 5010/5011 Indoor Fixed HD IP Dome Camera User Guide
OL-22669-01
Chapter 3 Operation
Events Tab
Creating a System Event Source
Step 1 Place your mouse pointer over the Events tab.
Step 2 Select Sources from the drop-down menu.
Step 3 Click in the Name box and type a user-friendly name (2 to 23 alphanumeric characters).
Step 4 Select System from the Type drop-down menu.
Step 5 Select the Boot check box to activate an event when the camera reboots.
Step 6 Click the Submit button to save the settings, or click the Reset button to clear all of the information you
entered without saving it.
Creating a Timer Event Source
Step 1 Place you mouse over the Events tab.
Step 2 Select Sources from the drop-down menu.
Step 3 Click in the Name box and type a user-friendly name (2 to 23 alphanumeric characters).
Step 4 Select Timer from the Type drop-down menu.
Step 5 Click in the Frequency box and type a number. Select seconds, minutes, hours, or days from the
Frequency drop-down menu.
Step 6 Click the Submit button to save the settings, or click the Reset button to clear all of the information you
entered without saving it.
Editing an Event Source
Step 1 Place your mouse pointer over the Events tab.
Step 2 Select Sources from the drop-down menu.
Step 3 Click the source profile that you want to delete from the defined source box located on the left side of
the page.
Step 4 Make any necessary changes to the available fields.
Step 5 Click the Submit button to save the settings, or click the Reset button to clear all of the information you
entered without saving it.
Deleting an Event Source
Step 1 Place your mouse pointer over the Events tab.
Step 2 Select Sources from the drop-down menu.
Step 3 Click the source profile that you want to delete from the defined source box located on the left side of
the page.