EasyManuals Logo

Cisco 7600 Series User Manual

Cisco 7600 Series
144 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #54 background imageLoading...
Page #54 background image
3-18
Cisco 7600 Series Router SIP, SSC, and SPA Hardware Installation Guide
OL-5052-08
Chapter 3 Overview: Cisco 7600 Series Router Shared Port Adapters
1-Port OC-12c/STM-4 ATM SPA Overview
The 1-Port OC-12c/STM-4 ATM SPA LEDs are described in Table 3-11.
1-Port OC-12c/STM-4 ATM SPA Interface Specifications
The physical layer interface for the 1-Port OC-12c/STM-4 ATM SPA is Optical Carrier-12 (OC-12), and
the 1-Port OC-12c/STM-4 ATM SPA is designed to comply with ATM specifications. The 1-Port
OC-12c/STM-4 ATM SPA provides one 622.08-Mbps OC-12 network interface for all supported
platforms.
The single SPA port accepts an SFP module with a duplex LC-type receptacle that allows connection to
single-mode or multimode optical fiber.
1-Port OC-12c/STM-4 ATM SPA Cables and Connectors
The 1-Port OC-12c/STM-4 ATM SPA provides the following optical fiber options:
Multimode—622.08-Mbps, OC-12 optical fiber (SONET STS-12c or SDH STM-4)
Use a multimode optical fiber that has a core/cladding diameter of 62.5/125 microns.
Single-mode—622.08-Mbps, OC-12 optical fiber (SONET STS-12c or SDH STM-4)
Use a single-mode optical fiber that has a modal-field diameter of 8.7 ±0.5 microns. (Nominal
diameter is approximately 10/125 microns.)
For single-mode and multimode optical fiber connections, you can use either a duplex LC-type cable (see
Figure 3-9) or two simplex LC-type cables, one for transmit (TX) and one for receive (RX).
Table 3-11 1-Port OC-12c/STM-4 ATM SPA LEDs
LED Label Color State Meaning
C/A Off Off Port is not enabled by software.
Green On Port is enabled by software, and there is a valid ATM signal
without any alarms.
Amber On Port is enabled by software, and there is at least one alarm.
A/L Off Off Port is not enabled by software.
Green On Port is enabled by software, loopback is off.
Amber On Port is enabled by software, loopback is on.
STATUS Off Off SPA power is off.
Amber On SPA power is on and good, and SPA is being configured.
Green On SPA is ready and operational.

Table of Contents

Other manuals for Cisco 7600 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 7600 Series and is the answer not in the manual?

Cisco 7600 Series Specifications

General IconGeneral
CategoryNetwork Router
Port DensityVaries by module
InterfacesGigabit Ethernet, 10 Gigabit Ethernet
RedundancyPower supplies
Power SupplyAC or DC, Redundant options available
Operating SystemCisco IOS XR
ManagementCLI, SNMP
Form FactorModular
DimensionsVaries by chassis model
WeightVaries by chassis model and configuration
Chassis Slots6, 9, or 13

Related product manuals