User dials 503 to send pages to phones configured as part of the GroupC group. If the phone configured in
GroupC receives a page during an active call, the page will be ignored.
Step 3 Click Submit All Changes.
Call Park
With call park, a call can be parked and then retrieved either from your phone or from another phone. The
following LED colors display on the line key when this feature is configured:
• Green LED—Call park is successfully configured.
• Amber LED—Call park is not configured.
• Red slow blinking LED—A call is parked.
Configure Call Park with Star Codes
You can configure call park so that the user can put a call on hold and then retrieve the call from either the
user's phone or another phone.
When configuring call park, the Call Park Code and the Call Unpark Code must match the Feature Access
Code configured on the server.
Before you begin
Access the phone administration web page. See Access the Phone Web Page, on page 80.
Procedure
Step 1 Select Voice > Regional.
Step 2 Enter *68 in the Call Park Code field.
Step 3 Enter *88 in the Call Unpark Code field.
Step 4 Click Submit All Changes.
Add Call Park to a Programmable Line Key
You can add call park to a line key to enable the user to temporarily store and retrieve calls. Call park is
supported on private lines and shared lines.
Before you begin
Access the phone administration web page. See Access the Phone Web Page, on page 80.
Cisco IP Phone 7800 Series Multiplatform Phones Administration Guide
170
Cisco IP Phone Administration
Call Park
To Next Page
Loading...
Need help?
General
