EasyManuals Logo

Cisco 7925G Series User Manual

Cisco 7925G Series
111 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #34 background imageLoading...
Page #34 background image
Cisco Unified Wireless IP Phone 7925G Series Deployment Guide 34
Non-overlapping channels must be used and allow at least 20 percent overlap with adjacent channels when deploying phones in
the 802.11b/g environment.
Signal Strength and Coverage
To ensure acceptable voice quality, the Cisco Unified Wireless IP Phone 7925G Series should always have a signal of -67 dBm
or higher when using 2.4 or 5 GHz and ensure the Packet Error Rate (PER) is no higher than 1%.
A minimum Signal to Noise Ratio (SNR) of 25dB = -92dBm noise level with -67 dBm signal should be maintained.
It is recommended to have at least two access points on non-overlapping channels with at least -67 dBm signal with the 25 dB
SNR to provide redundancy.
To achieve maximum capacity and throughput, the wireless LAN should be designed to 24 Mbps. Higher data rates (36-54
Mbps) can optionally be enabled.
Recommended to set the minimum data rate to 11 Mbps or 12 Mbps for 2.4 GHz (dependent upon 802.11b client support
policy) and 12 Mbps for 5 GHz, which should also be the only rate configured as a basic rate.
Due to the above requirements, a single channel plan should not be deployed.
For more information about signal strength and cell edge design, refer to the “VoWLAN Design Recommendations” chapter in
the Enterprise Mobility Design Guide at this URL:
http://www.cisco.com/en/US/docs/solutions/Enterprise/Mobility/emob41dg/eMob4.1.pdf
Ch 1
Ch 6
Ch 11
Ch 6
Ch 6
Ch 11
Ch 1
Ch 11
Minimum 20% Overlap

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cisco 7925G Series and is the answer not in the manual?

Cisco 7925G Series Specifications

General IconGeneral
WirelessIEEE 802.11a/b/g
Headset Jack2.5 mm
BluetoothNo
Frequency Band2.4 GHz, 5 GHz
Display2.0 in. TFT color display, 176 x 220 pixels
BatteryLithium-ion
AudioG.711, G.729
SecurityWPA, WPA2
Voice CodecsG.711, G.729, G.722
Battery Life8 hours talk time
Operating Temperature32°F to 104°F (0°C to 40°C)
ComplianceFCC

Related product manuals