Cisco Unified Wireless IP Phone 7925G Series Deployment Guide 40
If using 802.11b in a high multipath environment, lower data rates should be used in those areas (i.e. 1 and 2 Mbps).
Use of antenna diversity can also help in such environments.
Verification with Site Survey Tools
These are many tools and applications that can be utilized to verify coverage, quality and configuration.
• Cisco Wireless Control System (WCS) for Unified Wireless LAN management
• Cisco Wireless LAN Solution Engine (WLSE) for Autonomous Wireless LAN management
• Cisco Spectrum Expert
• AirMagnet (Survey, WiFi Analyzer, VoFi Analyzer, Spectrum Analyzer)
• Cisco Unified Wireless IP Phone 7925G Series
Cisco 792xG Neighbor List
The Cisco Unified Wireless IP Phone 7925G Series can be utilized to verify coverage by using the Neighbor List menu.
By Default, the Cisco Unified Wireless IP Phone 7925G Series only scans when the current signal lowers to a certain threshold,
so only one access point may be visible in the list if configured for auto scan mode.
To see all access points in the neighbor list menu, place a call from the Cisco Unified Wireless IP Phone 7925G Series to a
wired IP phone, where scanning occurs constantly while the phone call is active in auto scan mode.
Otherwise configure continuous scan mode.
The connected access point will be highlighted in red.
Access the neighbor list menu on the phone by pressing Settings > Status > Neighbor List
Cisco 792xG Site Survey
The Cisco Unified Wireless IP Phone 7925G Series has a Site Survey application, which is an offline mode that gathers
information about the access points for the configured network profile and generates and HTML report after exiting the
application.
To Next Page
Loading...
Need help?
General
