Cisco Unified Wireless IP Phone 7925G Series Deployment Guide 48
Cisco Discover Protocol (CDP)
G.722 capabilities can be configured on a phone by phone basis and optionally
override the system default.
By default the Cisco Unified Wireless IP Phone 7925G Series will show the
traditional screen with the four icons for directory, services, settings and line
access.
The Federal Information Process Standards (FIPS) mode can optionally be enabled.
When enabled, indicates that the phone will shift the call focus to incoming calls on
all lines. When disabled, the phone will only shift the focus to incoming calls on
the currently used line.
Indicates whether the Bluetooth device on the phone is enabled or disabled.
This parameter indicates whether the phone will perform a file system integrity
check as part of the firmware upgrade process. Enable this option to troubleshoot
file system issues. This feature may impact phone performance if it is enabled.
This parameter controls the minimum ring volume on the phone. This value is set
by the administrator, and can not be changed by an end user. The end user can
increase the ring volume, but may not decrease the ring volume below the level
defined. The minimum ring volume range is from 0 to 7, with 0 (silent) being the
default value.
Below shows the main phone screen (left) and line view (right) display options for the home screen.
Note: If configuring the “Admin Password” in Cisco Unified Communications Manager versions 5.1, 6.0, 6.1, 7.0, 7.1, 8.0 or
later and web access is set to “Full”, then it is recommended to enable TFTP encryption via the device security profile.
As of the 1.3(3) release, if settings access is set to “Disabled”, then the current ring volume will be locked in and will no longer
be configurable.
To configure product specific configuration options for the Cisco Unified Wireless IP Phone 7925G Series with Cisco Unified
Communications Manager Express, create an ephone template with the necessary options.
To Next Page
Loading...
Need help?
General
