Cisco Unified Wireless IP Phone 7925G Series Deployment Guide 70
If using 802.1x authentication via LEAP, EAP-FAST, PEAP or AKM (authenticated key-management) authentication modes,
then a username and password must be configured. AKM mode will use LEAP as the 802.1x method.
• Select whether to use Dynamic Host Configuration Protocol (DHCP) or configure static IP information.
• If option 150 or 66 is not configured to provide the TFTP server IP address via the network’s DHCP scope, then enter
the TFTP server IP address info.
• To enable PEAP with server validation, select “Validate Server Certificate” after importing the authentication server
certificate.
• When using EAP-TLS, select either “Manufacturing Issued” or “User Installed” for the “Client EAP-TLS
Certificate” option after selecting EAP-TLS.
Note: WEP128 is listed as WEP104 on the Cisco Unified Wireless LAN Controllers.
To Next Page
Loading...
