Procedure
Step 1 Press Contacts .
Step 2 Press Category, if it displays on the phone. Otherwise, skip the step.
Step 3 Select a BroadSoft directory. The default names are:
• Enterprise
• Group
• Personal
• Enterprise Common
• Group Common
When your administrator disables the directory individual mode, the phone only displays BroadSoft
directory.
Note
After you enter the directory, wait until the preload operation is complete. You can press Cancel to stop the
preload operation.
Step 4 Press Option, then select Search.
If your administrator disables the directory browse mode, you can find the Search softkey displayed on the
phone instead.
Step 5 Select a search criteria.
• In BroadSoft Enterprise or Group directory, search a contact by Last Name, First Name, User ID, Number,
Extension, Mobile phone, Department, or Email address.
• In BroadSoft Enterprise Common, Group Common, or Personal directory, search a contact by Name or
Number.
Step 6 Enter your search criteria, and press Search.
Edit Your Contact Type in Your BroadSoft Directory
Before you begin
Your administrator disables the directory individual mode for the BroadSoft XSI service.
Procedure
Step 1 Press Contacts .
Step 2 Press Category, if it displays on the phone. Otherwise, skip the step.
Step 3 Highlight the BroadSoft directory.
Step 4 Press Option.
Cisco IP Phone 7800 Series Multiplatform Phones User Guide
68
Contacts
Edit Your Contact Type in Your BroadSoft Directory
To Next Page
Loading...
Need help?
General
