Cisco ASR 5500 System Administration Guide

DescriptionCommandCLI Mode
Creates the MPLS protocol family
configuration modes, or configures
an existing protocol and enters the
MPLS-LDP Configuration Mode
in the current context. This
command configures the protocol
parameters for the MPLS protocol
family.
protocol ldpMPLS-IP Configuration Mode
Configure advertisement of Implicit
NULL or Explicit NULL label for
all the prefixes advertised by the
system in this context.
advertise-labels { explicit-null |
implicit-null }
MPLS-LDP Configuration Mode
Configures the Label Distribution
Protocol (LDP) neighbor discovery
parameters.
discovery { hello { hello-interval
seconds | hold-interval seconds }
| transport-address ip_address }
MPLS-LDP Configuration Mode
Enables Label Distribution Protocol
(LDP).
enableMPLS-LDP Configuration Mode
Configures the LDP Router ID.
router-id ip_address
MPLS-LDP Configuration Mode
Configures the LDP session
parameters.
session timers { hold-interval
seconds | keepalive-interval
seconds }
MPLS-LDP Configuration Mode
Table 18: VPN-Related Monitoring Commands
DescriptionCommandCLI Mode
Displays information regarding
BGP neighbors.
show ip bgp neighborsExec Mode show Commands
Displays all VPNv4 routing data,
routing data for a VRF or a
route-distinguisher.
show ip bgp vpnv4 { all |
route-distinguisher | vrf }
Exec Mode show Commands
Displays contents of VPNv6
routing table.
show ip bgp vpnv6Exec Mode show Commands
Displays all VPNv6 routing data,
routing data for a VRF or a
route-distinguisher.
show ip bgp vpnv6 { all |
route-distinguisher | vrf }
Exec Mode show Commands
Displays pool details including the
configured VRF.
show ip poolExec Mode show Commands
ASR 5500 System Administration Guide, StarOS Release 21.5
250
BGP MPLS VPNs
VPN-Related CLI Commands

Cisco ASR 5500 Specifications

General

Brand	Cisco
Model	ASR 5500
Category	Network Router
Language	English