Cisco ASR 9000 Series

Configuring Access Node Control Protocol on Cisco ASR 9000 Series Routers
Configuration Examples for Configuring ANCP on Cisco ASR 9000 Series Routers
QC-104
Cisco ASR 9000 Series Aggregation Services Router Modular Quality of Service Configuration Guide
OL-23108-02
Configuration Examples for Configuring ANCP on
Cisco
ASR 9000 Series Routers
This section contains the following examples:
• Configuring ANCP Server Sender Name: Example, page 105
• Configuring ANCP Neighbors: Example, page 105
• Mapping AN ports to VLAN Subinterfaces: Example, page 108
• Configuring ANCP Rate Adjustment: Example, page 109
• ANCP and QoS Interaction: Example, page 111
• QoS Policy Inconsistency on an Interface: Example, page 114
Step 3
end
or
commit
Example:
RP/0/RSP0/CPU0:router(config)# end
or
RP/0/RSP0/CPU0:router(config)# commit
Saves configuration changes.
• When you issue the end command, the system
prompts you to commit changes:
Uncommitted changes found, commit them
before exiting (yes/no/cancel)?
[cancel]:
– Entering yes saves configuration changes
to the running configuration file, exits the
configuration session, and returns the
router to EXEC mode.
– Entering no exits the configuration
session and returns the router to EXEC
mode without committing the
configuration changes.
– Entering cancel leaves the router in the
current configuration session without
exiting or committing the configuration
changes.
• Use the commit command to save the
configuration changes to the running
configuration file and remain within the
configuration session.
Step 4
show ancp summary detail
Example:
RP/0/RSP0/CPU0:router# show ancp summary
detail
(Optional) Shows generic ANCP configuration
information along with rate adjustment
configuration information.
Command or Action Purpose