Cisco ASR 903 Installation Guide

1-Port 100 Gigabit Ethernet Interface Module (1x100GE)
Figure 23: 1-port 100 Gigabit Ethernet Interface Module
The 1-port 100 Gigabit Ethernet interface module supports one CPAK optics port.
For information on supported CPAK modules, see Cisco ASR 900 Series Aggregation Services Routers Data
Sheet.
For more information about installing a 1x100GE module, see the Interface Module Installation.
2-Port 40 Gigabit Ethernet QSFP Interface Module (2x40GE)
The dual port 40 Gigabit Ethernet interface module supports the 40 Gigabit Ethernet port. The 40GE interface
is supported using QSFP+ optics. The figure below shows the interface module.
Figure 24: 2-port 40 Gigabit Ethernet Interface Module
Cisco ASR 903 and ASR 903U Aggregation Services Router Hardware Installation Guide
29
Overview
1-Port 100 Gigabit Ethernet Interface Module (1x100GE)

Cisco ASR 903 Specifications

General

Form Factor	Modular
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 95% non-condensing
Redundancy	Yes, redundant power supplies and route processors
Operating System	Cisco IOS XE
Power Supply	AC or DC
Switching Capacity	240 Gbps
Operating Temperature	-40°C to 65°C (-40°F to 149°F)
MTBF	200, 000 hours
Supported Protocols	IPv4, IPv6, MPLS, L2VPN, L3VPN
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, T1/E1