Cisco ASR 903 Installation Guide

• Ratcheting torque screwdriver with a Phillips head that exerts up to 30 pound-force per square inch (in-lb)
of pressure
• Crimping tool as specified by the ground lug manufacturer
• 18 AWG copper wire for the power cord
• Wire-stripping tools for stripping both 6 AWG and 18 AWG wire
• Tape measure and level
Only trained and qualified personnel should be allowed to install or replace this equipment. Statement 49
Warning
Unpacking and Verifying the Shipped Contents
When you receive your chassis, perform the following steps and use the Shipping Contents Checklist:
Step 1 Inspect the box for any shipping damage. If there is obvious physical damage, contact your Cisco service representative.
Step 2 Unpack the Cisco ASR 903 Router.
Step 3 Perform a visual inspection of the chassis.
Step 4 Use the table below to check the contents of the Cisco ASR 903 Router shipping container. Do not discard the shipping
container. You will need the container if you move or ship the Cisco ASR 903 Router in the future.
What to do next
Table 15: Cisco ASR 903 Router Shipping Container Contents
DescriptionComponent
Cisco ASR 903 Router chassisChassis
Fan tray
Power supplies
RSP
Interface modules
Cisco ASR 903 and ASR 903U Aggregation Services Router Hardware Installation Guide
69
Preparing for Installation
Unpacking and Verifying the Shipped Contents

Cisco ASR 903 Specifications

General

Brand	Cisco
Model	ASR 903
Category	Network Router
Language	English