Cisco ASR 903 Installation Guide

DescriptionComponent
Chassis rack-mount brackets (19-inch EIA)
Accessories kit
Three sets of screws:
• Front and rear rack-mount bracket screws (2 sets)
• Cable-management bracket screws
Six cable-management brackets (one per bracket)
One earth lug with two 10-32 screws.
1 RJ45 to RJ45 crossover cable
1 RJ45 to DB-9 (female) adapter
One disposable wrist strap (optional)
ESD, wrist strap (disposable)
Regulatory Compliance and Safety Information for the Cisco ASR 903 Router
Documentation
Check the container for the following optional equipment:
• Power cord if an AC power supply was shipped. There are no cords for the DC power supply
units.
• T1/E1 cable connector (required only for T1/E1 interface modules)
Optional equipment
Most Cisco documentation is available online. Documentation that is shipped with your Cisco ASR 903 Router
includes the Regulatory Compliance and Safety Information for the Cisco ASR 903 Router document, and
the Cisco ASR 903 Router Documentation Roadmap that contains information about the various documents
that are available online and the links to them.
Note
Cisco ASR 903 and ASR 903U Aggregation Services Router Hardware Installation Guide
70
Preparing for Installation
Unpacking and Verifying the Shipped Contents

Cisco ASR 903 Specifications

General

Form Factor	Modular
Storage Temperature	-40°C to 70°C (-40°F to 158°F)
Humidity	5% to 95% non-condensing
Redundancy	Yes, redundant power supplies and route processors
Operating System	Cisco IOS XE
Power Supply	AC or DC
Switching Capacity	240 Gbps
Operating Temperature	-40°C to 65°C (-40°F to 149°F)
MTBF	200, 000 hours
Supported Protocols	IPv4, IPv6, MPLS, L2VPN, L3VPN
Interfaces	Gigabit Ethernet, 10 Gigabit Ethernet, T1/E1