Cisco ASR 907 Installing

Table 1: Supported Hot Swapping Combinations
A900-RSP3C-400-WInterface Modules
Swapping allowed on all
Ethernet interface modules
8-port Gigabit Ethernet SFP Interface Module (8X1GE)
8-port Gigabit Ethernet RJ45 (Copper) Interface Module (8X1GE)
SFP Combo IM—8-port Gigabit Ethernet (8X1GE) +
1-port 10 Gigabit Ethernet (1X10GE)
Copper Combo IM—8-port Gigabit Ethernet (8X1GE)
+ 1-port 10 Gigabit Ethernet Interface Module(1X10GE
1-port 10 Gigabit Ethernet XFP Interface Module (1X10GE)
2-port 10 Gigabit Ethernet Interface Module(2X10GE)
8-port 10 Gigabit Ethernet Interface Module (8X10GE)
1-port 100 Gigabit Ethernet Interface Module (1X100GE)
2-port 100 Gigabit Ethernet (QSFP) Interface Module (2X100GE)
1
2-port 40 Gigabit Ethernet QSFP Interface Module (2X40GE)
8/16-port 1 Gigabit Ethernet (SFP/SFP) + 1-port 10 Gigabit Ethernet (SFP+) / 2-port 1 Gigabit Ethernet
(CSFP) Interface Module
1-port OC48/ STM-16 or 4-port OC-12/OC-3 / STM-1/STM-4 + 12-Port T1/E1 + 4-Port T3/E3 CEM
Interface Module
No support
16 x T1/E1 Interface Module
32 x T1/E1 Interface Module
8 X T1/E1 Interface Module
1-Port OC-192 or 8-Port Low Rate CEM Interface Module
48 x T1/E1 Interface Module
48 X T3/E3 Interface Module
4-Port OC3/STM-1 (OC-3)
or 1-Port OC12/STM-4
(OC-12) Interface Module
4-Port OC3/STM-1 (OC-3) or 1-Port OC12/STM-4 (OC-12) Interface Module
1
Supported since 16.10.1 release.
When you remove or insert a redundant module while the router is powered on and running, the router does
the following:
1. Determines if there is sufficient power for the module.
Installing the Cisco ASR 907 Router
27
Installing the Cisco ASR 907 Router
Hot-Swapping an Interface Module

Cisco ASR 907 Specifications

General

Brand	Cisco
Model	ASR 907
Category	Network Router
Language	English