Cisco Catalyst 9800-80 - CHAPTER 2 Supported Hardware Components; Supported EPA

CHAPTER 2
Supported Hardware Components
This chapter contains information about the supported hardware components on the Cisco Catalyst 9800-80
Wireless Controller.
• Supported EPA, on page 11
• Supported SFP Models, on page 13
• Supported Transceivers, on page 14
• Supported Crypto Module, on page 15
• Power Supplies, on page 15
Supported EPA
The following table lists the supported EPA on the Cisco Catalyst 9800-80 Wireless Controller.
DescriptionPID
Eighteen 1GE-ports that support small form-factor pluggable (SFP)
optical transceivers to provide network connectivity. Ports are numbered
0 – 17.
See the Supported SFP Transceivers section, for supported transceivers.
EPA-18X1GE
Ten 10GE-ports that support small form-factor pluggable (SFP+) optical
transceivers to provide network connectivity. Ports are numbered 0 – 9.
See Table 3: Supported SFP Transceivers, for supported transceivers.
EPA-10X10GE
EPA-1X40GE
EPA-2X40GE
EPA-1X100GE uses a CPAK module to provide network connectivity.
See Table 5: Supported CPAK Interface, for supported
CPAKs.
EPA-1X100GE
An EPA has two types of LEDs: an A/L (Active/Link) LED for each port on the EPA, and a STATUS LED,
as shown in the following figure.
Cisco Catalyst 9800-80 Wireless Controller Hardware Installation Guide
11