CHAPTER 4
Installing the Controller
This chapter provides procedures for installing the Cisco Catalyst 9800-80 Wireless Controller on an equipment
shelf, tabletop, or in an equipment rack.
• Installation Methods, on page 39
• Guidelines for a Standalone Equipment Shelf or Tabletop Installation, on page 40
• Installing the Controller on a Standalone Equipment Shelf or Tabletop, on page 40
• Guidelines for Rack Installation, on page 41
• Attaching Front Rack-Mount Brackets, on page 43
• Mounting the Controller in the Rack, on page 44
• Attaching the Cable Management Bracket, on page 46
• Chassis Ground Connection, on page 48
• Connecting Cables, on page 50
• Management Ethernet Port Cable Connection, on page 52
Installation Methods
The Cisco Catalyst 9800-80 Wireless Controllers are designed for standalone, 2-rail 19-inch rack-mount (front
rail only), and 4-rail 19-inch rack-mount (front and rear rail) installations.
Although rack-mounting is the preferred method of installation, you can mount the chassis on an equipment
shelf or tabletop.
Statement 1071—Warning Definition IMPORTANT SAFETY INSTRUCTIONS.
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work
on any equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard
practices for preventing accidents. Use the statement number provided at the end of each warning to locate
its translation in the translated safety warnings that accompanied this device.
SAVE THESE INSTRUCTIONS
Warning
Cisco Catalyst 9800-80 Wireless Controller Hardware Installation Guide
39
To Next Page
Loading...
