Figure 13: Attaching the Grounding Lug to the Ground Connector of the Cisco Catalyst 9800-80 Wireless Controller
Grounding screws3Ground connector on the chassis1
Ground symbol4Chassis ground lug2
Step 6 Use the Number 2 Philips screwdriver to carefully tighten the screws until the grounding lug is held firmly to the chassis.
Do not over tighten the screws.
Step 7 Connect the opposite end of the grounding wire to the appropriate grounding point at your site to ensure an adequate
chassis ground.
Connecting Cables
Keep the following guidelines in mind when connecting any external cable to the Cisco Catalyst 9800-80
Wireless Controller:
• To reduce the chance of interference, avoid crossing high-power lines with any interface cables.
• Verify all the cabling limitations (particularly distance) before powering on the system.
Cisco Catalyst 9800-80 Wireless Controller Hardware Installation Guide
50
Installing the Controller
Connecting Cables
To Next Page
Loading...
